Preamps

For anyone that wants to modify their equipment or has a question relating to their installation issues
Forum rules
Aussiescanners takes no responsibility for any modification undertaken, these are to be done at your own risk and should only be performed by those with good knowledge of radio and soldering.
Post Reply
User avatar
Radio_Australia
Registered User
Posts: 156
Joined: Tue Sep 23, 2014 5:52 pm
Location: Australia

Preamps

Post by Radio_Australia » Wed May 22, 2019 9:40 pm

Who has a uniden sds100 and uses a pre amp ?

What model are you using , any success ?




Last edited by Radio_Australia on Wed May 22, 2019 9:40 pm, edited 1 time in total.

User avatar
Radio_Australia
Registered User
Posts: 156
Joined: Tue Sep 23, 2014 5:52 pm
Location: Australia

Re: Preamps

Post by Radio_Australia » Sun May 26, 2019 8:33 am

No one with a preamp ?

User avatar
X-Firey
Registered User
Posts: 166
Joined: Sun Aug 28, 2016 11:38 am
Location: Melbourne S/E

Re: Preamps

Post by X-Firey » Sun May 26, 2019 7:16 pm

I have experimented with pre amps in the past with various uniden analogue scanners.
The pre amp amplified the signal ok but also the back ground noise...
From memory the unit I used was a GRE Super Amplifier. I believe this is the type of pre amp you are referring to.

User avatar
terryhaynes
Forum Manager
Posts: 115
Joined: Sun Sep 23, 2007 5:13 pm
Location: RUNCORN, QLD
Contact:

Re: Preamps

Post by terryhaynes » Fri Jun 14, 2019 6:24 pm

Rubbish don't waste your money!

Post Reply