CS-400PRO for Icom IC-400PRO

Discussion on Icom technologies, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
Post Reply
RoyButterfield
Newly Registered Users
Posts: 1
Joined: Thu Oct 17, 2013 8:34 am

Re: CS-400PRO for Icom IC-400PRO

Post by RoyButterfield »

Why do I need a dealer ID ?

User avatar
rochedalescan
Founder
Posts: 1631
Joined: Fri Jun 01, 2007 5:08 pm
Location: Brisbane
Contact:

Re: CS-400PRO for Icom IC-400PRO

Post by rochedalescan »

Are you talking about product I.D ? on installation ? if so read the document called READ ME and it has that information in there.
Shane Logan
Aussiescanners Founder

Australia's Premier Communications forum!
~ Please contact Phil for administration enquiries ~

Post Reply