Icom Rx7 Software and cloning cable

Discussion on Icom technologies, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
Post Reply
Flyer
Newly Registered Users
Posts: 2
Joined: Sun May 29, 2011 5:23 pm

Icom Rx7 Software and cloning cable

Post by Flyer »

New to AussieScanners, great site some very interesting stuff.

Have purchased Icom RX7 however no programming cable (OPC-478UC) or software CS-RX7.
Is shareware software available and a place to purchase cable at a reasonable price. Any info much appreciated
Thanks

User avatar
Phantom
Forum Manager
Posts: 1305
Joined: Thu May 15, 2008 12:28 pm
Location: SE QLD

Re: Icom Rx7 Software and cloning cable

Post by Phantom »

Best place to start would be Here

As for software, shareware - I doubt it ....

Flyer
Newly Registered Users
Posts: 2
Joined: Sun May 29, 2011 5:23 pm

Re: Icom Rx7 Software and cloning cable

Post by Flyer »

Cheers

Post Reply