IC-F4033S software needed

Discussion on Icom technologies, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
Post Reply
allnitetime
Newly Registered Users
Posts: 2
Joined: Sun Apr 07, 2013 2:13 am

IC-F4033S software needed

Post by allnitetime »

IC-F4033S
128 Ch. 4W UHF Handheld Transceiver 400-470Mhz, or 450-520MHz band, 12.5kHz &/or 25kHz Channel Spacing

The CS-F3020/F5010/F5020 cloning software is designed to be used for data entry, settings and programming for the IC-F3020/F4020 series, IC-F5010/F6010 series, and IC-F5020/F6020 series transceivers.

CS-F3020
Cloning software
OPC-478
RS232 programming cable
OPC-478UC
USB programming cable

Looking for the australia version should be 2011 year

Post Reply