key pad

Discussion on Icom technologies, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
Post Reply
tobacie
Newly Registered Users
Posts: 2
Joined: Sun Jun 23, 2013 11:23 am

key pad

Post by tobacie »

just purchased the ic-208h. cant seem to unlock microphone. when[ptt] is pushed OFF is displayed on main screen.

User avatar
Phantom
Forum Manager
Posts: 1305
Joined: Thu May 15, 2008 12:28 pm
Location: SE QLD

key pad

Post by Phantom »

Read the manual?

Vkfour
Senior Member
Posts: 369
Joined: Tue Oct 05, 2010 11:27 am

Re: key pad

Post by Vkfour »

First, read the manual, then press the Set/Lock switch in for one second. That's on the top left side of the tuning dial. It's on page one.

tobacie
Newly Registered Users
Posts: 2
Joined: Sun Jun 23, 2013 11:23 am

Re: key pad

Post by tobacie »

iv read manual!!.. and tried the same steps over again. still displayed OFF...I am able to hear, but can not speak.

User avatar
Phantom
Forum Manager
Posts: 1305
Joined: Thu May 15, 2008 12:28 pm
Location: SE QLD

Re: key pad

Post by Phantom »

What freq are you trying to transmit on?

Post Reply