iCOM IC-F2010

Discussion on Icom technologies, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
Post Reply
Barra55
Newly Registered Users
Posts: 1
Joined: Wed Apr 25, 2018 4:49 pm

iCOM IC-F2010

Post by Barra55 »

Hi All. Trying to chase down the programming solution for this beast. I recall it was a DOS based program.

Post Reply