Page 1 of 1

436 programming

Posted: Fri Dec 13, 2019 9:12 am
by vk2gel
Hi all, I have an NXDN upgraded 436 and would like to monitor Sydney council https://www.radioreference.com/apps/db/?sid=7429

I have Sentinel so can I use it to program the 436 with the above database directly?

I tried manual programming but the 436 asks for an LCN?

Any help appreciated, thanks G

Re: 436 programming

Posted: Fri Dec 13, 2019 10:29 am
by Radio_Australia
Program all frequencies for system under correct system type , then run LCn finder till it completes

Sent from my SM-G935F using Tapatalk


Re: 436 programming

Posted: Fri Dec 13, 2019 1:17 pm
by Radio_Australia
Bare in mind radio reference is very out of date , and this system was last updated in 2015 , so maybe missing some new frequencies, or the system has totally changed

Re: 436 programming

Posted: Fri Dec 13, 2019 4:36 pm
by vk2gel
Legend, thanks RA.

With the help of the RR forum, also found that I needed to make sure the system is active, not avoided, quick key enabled, and in ID search mode.

What an adventure, G